Quick Answer: Can Speaker Cable Be Too Thick?

How many watts can 14 gauge speaker handle?

750 watts14 AWG Speaker Wire can handle up to 750 watts of power at 20 ft Cable Runs: 14 guage speaker wire can carry up to 750 watts of power with 20 ft of speaker wire and a 4 ohm speaker load with 37 watts lost at the speaker terminals..

Does electricity move faster in thick or thin wires?

The thin wire will conduct electricity, but there is more electrical resistance. The thicker wire is like the four lane highway. There’s a lot less electrical resistance, and as a result, that light bulb burns brighter because more electricity can reach it.

What’s the thickest speaker wire?

Thick wire (12 or 14 gauge) is recommended for long wire runs, high power applications, and low-impedance speakers (4 or 6 ohms). For relatively short runs (less than 50 feet) to 8 ohm speakers, 16 gauge wire will usually do just fine. It’s cost-effective and easy to work with.

What happens if wire gauge is too big?

using larger wire will not hurt anything or cause any overload. The larger wire will cost more, the pathway or where it has to fit, and the physical size of the connecting means (ie. the size of terminal or clamp it has to fit in), will all be determining factors in just how big is too big.

Do speakers get worse with age?

Distinguished Member. If a speaker is well looked after etc. then their lifespan can be in the decades. In a couple of years there will be no degradation in sound quality as long as they have been looked after.

Does speaker wire size matter subwoofer?

The speaker wires If your sub system is going to put out more than 1,000 watts RMS, you can use 12-gauge speaker wire. But 16-gauge speaker wire works well for most installations.

Can I use electrical wire for speakers?

So, can I use an electrical wire as a speaker cable? To answer the question posed at the start of this article – yes, you can use a regular electric wire as a speaker cable, as long as it comes with two same-sized conductor wires.

Do subwoofers get louder as they break in?

Subwoofers should not get louder as they break-in. … You may even find that your manufacturer does not recommend a break-in process and instead has other recommendations for playing various sounds when you initially use your subwoofer and other speaker equipment.

Why do we prefer thick connecting wires?

1 Answer. The resistance of connecting wires should be almost negligible. For this thick wires are used . since a thicker wire has a small resistance and the wires are made of copper because the resistivity of copper is low.

Does a thicker or thinner wire have more resistance?

The relationship between resistance and wire length is proportional . The resistance of a thin wire is greater than the resistance of a thick wire because a thin wire has fewer electrons to carry the current. The relationship between resistance and the area of the cross section of a wire is inversely proportional .

Can a wire be too thick?

Simple answer is no. The thicker the wire then the lower the resistance. However, the thicker the wire, the more costly it is, it is not as easy to bend, it is heavier. You also will not be able to fit it to a particular connector if too thick.

What gauge wire is best for speakers?

Speaker wires that are anywhere between 12 to 16 gauge are most commonly used for connecting speakers to an amplifier or an Audio/Video (A/V) receiver. A lower-gauge number indicates a thicker wire, while a higher-gauge number indicates a thinner wire.

Do speakers sound better over time?

The good news is your speakers will absolutely sound better after the initial break in period. … Due to the rigidness of your new speakers, they will not be as dynamic until they have had a chance to move and become more flexible.

What’s special about speaker wire?

Speaker wire is a type of wire used for connecting speakers to a sound source such as an amplifier or receiver. Speaker wire is low voltage and doesn’t cause any shock. However, it’s insulated to prevent short circuit.

Can you break speakers by playing music too loud?

Absolutely. It’s possible to damage the drivers in any speaker by playing the music too loud. You can go in to the Music app settings and enable volume limit by sliding the toggle down thus lowering the max volume level.

Is thick speaker wire better?

Thicker wires are better: It’s true that for long runs, thicker wires are better at reducing the effects of resistance. But for most set ups (those with speakers within 100 ft of the amplifier), 16-gauge lamp cord is fine. For speakers 100 to 200 ft. from the amp, experts suggest use 14 gauge.

Can I use 18 gauge wire for speakers?

All speakers work best with the largest gauge wire possible, 18 being the “standard”. … The manual states that up to 20 ft an 18 gauge wire is fine with 16 and 14 gauge for longer runs.

Should I use 2 conductor or 4 conductor speaker wire?

Designed for bi-amping, which means using two amplifiers for a single speaker, four-conductor speaker wire has a higher threshold for power compared to two-conductor speaker wire. Two-conductor speaker wire is effective when wiring a single speaker powered by a single amplifier.